Spirit System

Hi,

I want to use my Jeti Mezon Controller and the governor from the Mezon but I don't get any signal on THR.
The Mezon dosen't even inizialize.

what might be my problem ? What configuration should i be beware of ?

Thanks for any help

Best regards

Robert

Hi,

please set Throttle Range to 1000 - 2000us. Then it will work.

Hi,

Yes I allready checked that the throttle range is set to 1000 - 2000 but this dosen‘t help
I also tried to connect a servo instead of the esc and it also shows no reaction !

Any further Ideas ?

Best regard

Robert

Please make sure that Throttle is assigned at Channel 1 and in your radio there is default channel layout - Model Type set to Spirit.

Checked everything twice and it diden‘t work ! So yesterday evening tokk frustated 3 beer and went to sleep !
This morning i wanted to start all over and gues what „IT WORKS“

I don‘t know what wend wrong, probably I just should have started the Sytem new.

So many thanks anyway for the quick replys .

Best regards

Robert

Sometime beer can resolve an issue