Spirit System

hi, i have made the sistem work through EX-BUS but my question is, they say you have to make a Modification to the cables on the ALIGN governor to work....

1.-anybody has some pictures on how this looks after the mod?
2.- The say you have to plug one of the connectors on the ELE/PIT/AIL port.... but that one has already been used by the EX-BUS
3.- any body has a picture of an example on this setup

Thanks in advance

1. All about modification:
https://manual.spirit-system.com/index. ... RPM_Sensor

2. This is not a problem. Sensor is using different pins.