Page 1 of 1
Additional servo for retracts | Micro Spirit | Blade 230
Posted: Fri 25. Aug 2023 6:23:27
by 3D3D3D
On the Blade 230 Helicopter (with Spektrum DSMX Satelite) I have all channels occupied except for the Rudd channel. I installed the ESC on the AUX channel as per the instructions and the signal line for the rear motor on channel 4 (I think). Now I need an extra servo for a retractable landing gear. Can I use the Rudd channel on the micro spirit for this?
Thanks in advance
Best Regards
Re: Additional servo for retracts | Micro Spirit | Blade 230
Posted: Fri 25. Aug 2023 21:28:58
by Mattes61
Hello,
in my opinion is this not possible - the GT for example has the possybility for Output at channel 0 or Aux2 you see that in spirit settings in channel/function there is no possibility to Output to RUD !
Regards
Re: Additional servo for retracts | Micro Spirit | Blade 230
Posted: Sat 26. Aug 2023 4:10:52
by 3D3D3D
Mattes61 wrote:Hello,
in my opinion is this not possible - the GT for example has the possybility for Output at channel 0 or Aux2 you see that in spirit settings in channel/function there is no possibility to Output to RUD !
Regards
Thanks for your feedback! I also think that it is not possible.. But I still hope that it is somehow possible..