Page 1 of 1
setup Wizard question
Posted: Thu 31. Oct 2024 23:07:27
by Renzo
Hallo All,
Do the 6 degrees have to be positive? in my setup Wizard I have -6 degrees is it right?thanks everyone for your help
Re: setup Wizard question
Posted: Fri 01. Nov 2024 1:49:32
by ExCCHP
Which blade are you using to take the angle measurement?
Are the blades aligned with the boom?
AFAIK you should always take measurements with the blade over the nose of the canopy.
Re: setup Wizard question
Posted: Fri 01. Nov 2024 7:43:00
by HeliMLM
it does not matter if you take the blade over the boom or over the nose. and depending on the pitch gauge you are using and how it was zeroed and which blade you are using, there could be + or - 6°.
Re: setup Wizard question
Posted: Fri 01. Nov 2024 12:38:18
by Renzo
Tank for your help...i can go fly:)
Re: setup Wizard question
Posted: Fri 01. Nov 2024 13:17:51
by franz88
don't get confused
It doesn't mean 6 degrees of cyclic
6 degrees in the geometry
and in cyclic ring supported degrees from your mechanics helicopter (about 10 degrees)