Issue with JR Xbus protocol - channels 1 and 5 glitching

In case you would like to see some new feature in the software you can share it right here!
You can also report issue or odd behavior here.
Post Reply
Myster Mask
Posts: 21
Joined: Tue 03. May 2016 10:15:10

Hello,
using the JR XBUS with a XG14 as transmitter an RG613BX as reveiver, 2 channels (1-THR and 5-GYR5) are dropping to absolute 0 on the DIAGNOSTIC tab, randomly between 3 and 4 times within 1 second.

The pace this happens (every 6.1~.2 second) is very steady.

To determine if it was not the receiver sending wrong data, I have replace the Spirit by a Xbus-to-PWM-converter and plugged a servo, which remained absolutely steady.
This leads me to thinking there is an issue in interpreting the Xbus data.

This does not happen when using SRXL protocol, which leads me to thinking the issue comes only when reading the JR XBUS protocol.
Top
Post Reply

Return to “Wishlist / Bug report”