Page 1 of 1
How to Connect the Unisens-E to Spirit GT ?
Posted: Thu 12. Jun 2025 19:41:00
by SpUDmONSTeR
Hello,
how do I connect the Unisense-E as a telemetry device to the Spirit GT? And which protocol do I set in the Unisense software?
Kind regards, Norb
Re: How to Connect the Unisens-E to Spirit GT ?
Posted: Fri 13. Jun 2025 5:58:54
by Habásek
I use Unisens-E and have it connected as a HOTT telemetry sensor:
https://manual.spirit-system.com/index. ... _Telemetry
Re: How to Connect the Unisens-E to Spirit GT ?
Posted: Thu 19. Jun 2025 5:42:27
by SpUDmONSTeR
I have also connected it as described but the Unisens does not get any power. If I also connect power and ground to the Unisens and only connect the signal line and ground to the Sat 1 port of the Spirit GT, the Unisens gets power but the sensors get no information. I have tried it in the SM software with HoTT ESC, GAM and EAM, the sensors are found in EdgeTX but no data comes from the Unisense.
Kind regards, Norb