Spirit System

So I am just making my first foray into fixed wing as I normally fly Helis. I have a basic trainer with 2 ailerons and flaps. I have bound the Wave to the RX7, elevator and rudder are fine, flaps fine but I am only getting 1 aileron working, I have them plugged in to channels 2and 3 on then RX7, channel 3 appears to be responding but nothing from channel 2, tried reversing and nothing so I have no idea. Also have no throttle, esc just beeps so no idea what’s going on there also.

You need to set the output to ch2 in Channels in Wave - now Spirit telemetry will be there.
Or put the second aileron on ch 5/6/7 ... as needed

Can’t get this to work at all, o well back to Vbar then, shame really I quite like the Wave but a serious lack of information on how to set up even a basic model.

You only have to set output to Servo at CH2. Model - Receiver - Output Mapping menu (second page)
Takes just 10 seconds.

Default output settings is for Spirit RX protocol. Good idea, we can make it automatic in next update.

Managed to get it sorted, thanks for you help on that. I recalibrated the throttle, that was also showing unassigned in the receiver channels, but I have that working now.