Page 1 of 1

Mounting GeoLink In Cabin of Scale Helicopter

Posted: Tue 09. Sep 2025 21:48:06
by ShapeShifter
I would like to mount the GeoLink on the floor of the cabin at the nose to take advantage of the laser on the bottom (with a hole in the bottom of fuselage for laser). I need a longer cable to reach from the Spirit GT. I can make my own cable.

The manual says, "Longer cable is possible and will be available. For GPS itself a shorter cable is better, because any additional cables attached to the module and Spirit unit could distort the signal" What is the problem with a longer GeoLink cable if routed away from other electronics and magnets?

Re: Mounting GeoLink In Cabin of Scale Helicopter

Posted: Wed 10. Sep 2025 21:01:51
by ZeXx86
Hello,

cable up to 60cm is fine and should be without any side effect.
Longer cable could add electrical noise and lower incoming GPS signal reception sensitivity.