Page 1 of 1
Wiring Spirit 3 with Jeti Recivers
Posted: Tue 21. Apr 2026 9:54:13
by helischober
Does the wiring Spirit 3 at the same as Spirit 2 or other?
because the discription on Spirit Wiki are not clear.it shoes only the wiring for Spirit 2 on place for Spirit 3
Re: Wiring Spirit 3 with Jeti Recivers
Posted: Tue 21. Apr 2026 10:05:01
by Sepp62
It is like GT. Just plug your receiver into RUD.
Re: Wiring Spirit 3 with Jeti Recivers
Posted: Tue 21. Apr 2026 10:11:32
by ZeXx86
Confirm. Wiring is same as GT,
please see our manual:
https://manual.spirit-system.com/index. ... _Spirit_GT
Re: Wiring Spirit 3 with Jeti Recivers
Posted: Tue 21. Apr 2026 10:40:01
by helischober
Thank's for clearify.
And how do they set up the cabling for telemetry, e.g. YGE?
Re: Wiring Spirit 3 with Jeti Recivers
Posted: Tue 21. Apr 2026 10:42:20
by ZeXx86
Please proceed according our manual:
https://manual.spirit-system.com/index. ... _Telemetry
More recent YGE ESCs have required telemetry cable in the box.
Re: Wiring Spirit 3 with Jeti Recivers
Posted: Tue 21. Apr 2026 10:43:56
by helischober
Thank you very much for that information too
Re: Wiring Spirit 3 with Jeti Recivers
Posted: Wed 22. Apr 2026 11:57:29
by helischober
Will all ESC data from, say, the YGE ESC be transferred, or just the data mentioned in the wiki?
Re: Wiring Spirit 3 with Jeti Recivers
Posted: Wed 22. Apr 2026 17:53:24
by Sepp62
Just the ones mentioned in the Wiki (7 values). You also can see the supported values from the PC config app Advanced/ESC telemetry/Telemetry variables (depending on the selected ESC type).
"External" sensors are currently limited to one physical interface (Sat1) and ESCs (besides the Xicoy ECU).
It is a pity, that there is no(t yet a) generic telemetry interface, which supports every type of telemetry value. The Spirit proprietary interface is not yet documented, so there are no 3rd party solutions also (oXs, uniSense, vSpeak etc.).