Spirit System

I have a Spirit RS3 ( intern jeti receiver) and Geolink V2.
I want to connect a second jeti Rex3 receiver and a R900NG receiver.
How must I connect and in wich port must I connect them?

Desmond

Hello,

it has to be connected at the E1 port. From then you will see this receiver in the Device Explorer.
Make sure that E1 port is still configured as JETI EXBUS. Not JETIBOX/Sensor.

So the rex 3 must be connected to the E1 port with the JST-RX adapter cable.
I asume the Geolink to the E2 port. Where does the R900NG receiver go in ?

Desmond

Unfortunately connecting third JETI receiver is not supported.
Nothing can be connected at the E2 pin otherwise main receiver connection will be lost.
GeoLink is always connected at the SAT2 port.