Wave
Posted: Tue 17. Nov 2026 19:00:50
Hello Spirit Team,
I am using the Spirit Wave together with a Spirit W1 and really appreciate being able to set up the entire unit directly from the transmitter without needing a PC.
However, I noticed one small missing detail during setup: When assigning a switch to a stabilization mode (e.g., Stabi Normal) directly in the Wave's setup menu, there is no live status indicator showing whether the function is currently active or inactive (like the 0 / 1 indicator in the PC software).
To be 100% sure that my switch assignment was actually triggering Stabi Normal, I still had to connect the W1 to my PC just to verify the active state.
Are there any plans to add a simple live status indicator (e.g., Active / Inactive or 0 / 1) directly inside the Wave's Stabi menu in a future firmware update? That would make a PC-free setup at the field completely self-contained and much more reassuring.
Best regards,
Lutz
I am using the Spirit Wave together with a Spirit W1 and really appreciate being able to set up the entire unit directly from the transmitter without needing a PC.
However, I noticed one small missing detail during setup: When assigning a switch to a stabilization mode (e.g., Stabi Normal) directly in the Wave's setup menu, there is no live status indicator showing whether the function is currently active or inactive (like the 0 / 1 indicator in the PC software).
To be 100% sure that my switch assignment was actually triggering Stabi Normal, I still had to connect the W1 to my PC just to verify the active state.
Are there any plans to add a simple live status indicator (e.g., Active / Inactive or 0 / 1) directly inside the Wave's Stabi menu in a future firmware update? That would make a PC-free setup at the field completely self-contained and much more reassuring.
Best regards,
Lutz