Page 1 of 1

GeoLink v2 update failed, but still connects and displays v1.4.1

Posted: Fri 20. Nov 2026 9:30:16
by nphan
Hi Spirit Support Team,

I am experiencing an issue while updating the firmware on my GeoLink v2, which is connected to a Spirit GTR running firmware v4.0.5.

Here is what happened:

- I attempted to update the GeoLink from v1.3 to v1.4.1.
- The update progress completed, but the final status showed "Failed" and advised me to power cycle the unit to continue the update.
- After reconnecting the power, there was no option to "Continue," so I manually selected v1.4.1 and started the update again. However, it continues to fail repeatedly.
- When I disconnected and reconnected the power once more, the GeoLink still connected properly to the Spirit unit, and the software now displays the firmware version as v1.4.1.

Could you please help me with the following questions?

1. How can I verify if the GeoLink v1.4.1 update actually succeeded, or how can I properly force a clean re-update?
2. Given the "Failed" status messages, is the unit currently safe to fly?

Thank you for your assistance.

Best regards,
Nhan

Re: GeoLink v2 update failed, but still connects and displays v1.4.1

Posted: Fri 20. Nov 2026 14:07:28
by ZeXx86
Hello,

according your description the update proceeded correctly. GeoLink will bootup only if firmware is fully uploaded. Status version shows correct version now, but it is strange that failure message will show up.
Is there ESC telemetry cable connected at the SAT1 port?

Re: GeoLink v2 update failed, but still connects and displays v1.4.1

Posted: Fri 20. Nov 2026 14:50:40
by nphan
Hi Spirit Support Team,

Thank you for the reply,

Apologies for the confusion in my previous message, I misremembered the prompt.
The software actually instructed me to restart the software while keeping the power connected (not to power cycle the unit).

Here is my current connection,
- Spirit GTR and GeoLink v2 are connected via the SAT2 port.
- The USB cable is connected to the SYS port.
- Power is supplied through CH0.
-Other port is not connected.

Here is the video showing the issue after two update attempts:
2:30 for 1st failed and 6:50 for second failed

[youtube]https://youtu.be/WcW3bnLUSLA?si=3H16i3LnGozED5qX[/youtube]

Please let me know what you recommend for the next steps.
Best regards,
Nhan