Pitch change during bank switch !

In case you do not know something or you are not sure, here is the right place for your question.
Post Reply
Dawiev
Posts: 139
Joined: Sat 28. Feb 2015 3:08:53

Hi, I'm stumped on this and need some help please.

When I switch from Bank 0 to Bank 1, the swash moves by 3 degrees negative pitch. In the diagnostic tab it doesn't change and in the monitor screen (DX9) neither.

I've just started setting the unit up and Stabi is disabled in all banks still



Why is this ? Where to look ? What did I do wrong ? ;)
Top
ZeXx86
Site Admin
Posts: 12831
Joined: Mon 29. Apr 2013 16:06:44
Contact:
Contact ZeXx86

Hi,

most probably your Collective pitch range is different for each Bank.
You can check Limits tab to see the difference.
Spirit System developer
Top
Dawiev
Posts: 139
Joined: Sat 28. Feb 2015 3:08:53

Hi, thanks for the quick reply ! I will check it tonight.

So that I understand what to check : I did reset the unit to factory settings and started from scratch. I made all the setup and changes in Bank 0. I assigned the channel in the TX and tested the switching of the banks. This is when I noticed the swash movement.

Do I have to do some sort of factory reset for each individual bank ?

Are there specific settings that I have to repeat in each bank ? Settings that does not get carried over from Bank 0 to 1 & 2.
Top
ZeXx86
Site Admin
Posts: 12831
Joined: Mon 29. Apr 2013 16:06:44
Contact:
Contact ZeXx86

Actually resetting the unit to factory settings caused that the difference is visible.

If the unit is new, it is always in factory settings, but bank 1 and bank 2 is clear.
So if you are doing initial setup with bank 0 then it is copied to bank 1 and 2 automatically and this problem can't happen.

At the moment your settings are different between banks so you have to only load settings from bank 0 to bank 1 and 2.
Spirit System developer
Top
Dawiev
Posts: 139
Joined: Sat 28. Feb 2015 3:08:53

Hi, Fixed ! It was indeed very different. Also found the bank comparison method with the BT module that shows the differences. Super helpful and very nice verification before flying !

Have some more questions. Best to post them new with meaningful topics so it is visible ?

First few flights looks very promising already. Some tuning to do, but I look forward to it !

Ps. Apart from the technical abilities of the unit, the commitment and promptness of your support certainly sets this unit above other experiences I've had. Thank you !!!!! ;)
Top
Post Reply

Return to “Support”