Page 1 of 1
Spirit gets no voltage, no red LED ...
Posted: Thu 20. Aug 2015 19:31:28
by Franky13
Hello Thomas!
According to the new firmware version 1.2.1 I have no power in the Spirit?
Have some trials started, no success.
The red LED is off!
Where is the problem?
Greeting Frank
Re: Spirit gets no voltage, no red LED ...
Posted: Thu 20. Aug 2015 19:45:10
by ZeXx86
Hello Frank,
it seems that flashing process was not successfull so that is the reason why unit is not working.
Did you checked the firmware file (checksum) before update?
It is possible to flash the firmware again in recovery mode if this is the case.
Re: Spirit gets no voltage, no red LED ...
Posted: Thu 20. Aug 2015 20:04:13
by Franky13
OK,
but how can I reset the Spirit again?
I can not open the software ...
Re: Spirit gets no voltage, no red LED ...
Posted: Thu 20. Aug 2015 21:22:05
by ZeXx86
I have sent you PM with the guide for flashing in the special mode.
Re: Spirit gets no voltage, no red LED ...
Posted: Fri 21. Aug 2015 6:12:01
by Franky13
Hello Thomas!
Thanks for the instructions but I think that I will send you the Spirit.
how do we go on?
Greeting Frank