Spirit System

Hi
I have tried the rescue with my logo 600 (firmware 1.3 and red spirit) It works perfectly in acro mode, but in normal mode , and when I activated the rescue in inverted flight (normal mode) , I was very surprised by the rotation rate of the flip to recover the heli skids down. It is almost violent.

I tried 2 or 3times, but I stopped because I was afraid to boom strike my logo...

Is it possible to adjust the rotation rate of this flip, other than reducing the cyclic ring setting ?

It's quick but nowhere near problems.
Your Logo will have no issues with it!

Lower the cyclic ring, at least that is what I had to do. My 450 allowed very large defelctions and I followed the manual and set up max possible. That rescue flip was fast and violent!

Hakan wrote:Lower the cyclic ring, at least that is what I had to do. My 450 allowed very large defelctions and I followed the manual and set up max possible. That rescue flip was fast and violent!

Yes I agree with you.
May be I am wrong, but I feel the rescue flip is even faster with the new firmware 1.3.

It would be nice to have the possiblilty to slow down a little the rescue flip ( in rescue normal mode) with a suitable setting.

+1 for a submenu in which we can trim the flip rate from inverted to skid down.