servos go crazy when saving banks

[djhandz]

Setting up spirit pro software/firmware 1.3.1 when making changes and saving banks the servos go crazy and i have to disconnect power any ideas scared of damaging my servos

[ZeXx86]

Hello,

could you tell me, what is your receiver type and if it happen when you turn off the receiver?

[djhandz]

I am using 2 dsmx sats wired direct to unit with a dx9

[ZeXx86]

Great, then can you try if the problem is there when you start the unit without transmitter?

[djhandz]

I will test without tx after work. Thanks. Thinking ahead without the tx on its not possible to set limits/pitch range would a work around be to setup with tx on set limits but then before i go to save the settings turn off the tx??

[Coco66]

I think they want to see if the servos behave like that when not "bound". Maybe that's what happens while you are saving banks, some re-initialization happens that "suspends" the bind. Just speculating ))))))

[elfew]

I can confirm that. I got this in 1.2 too, but I dont know how to reproduce it. Same configuration 2x dsmx sats.

Servos just go crazy

[djhandz]

Tested with tx off and no issues.. but how do i set limits and pitch with tx off ??

[ZeXx86]

You can use your TX without any problem all the time.
Does the issue happen each time?

[djhandz]

Yes each time i go to save when the tx is on they go crazy