[SOLVED] 1.3.1 failure

In case you do not know something or you are not sure, here is the right place for your question.
Post Reply
Rcpassa
Posts: 55
Joined: Thu 15. Oct 2015 1:41:38

What Do I do next?
Top
ZeXx86
Site Admin
Posts: 12832
Joined: Mon 29. Apr 2013 16:06:44
Contact:
Contact ZeXx86

When your LED blinks for a while, then only you have to do is:
1. Start the software and then press No when prompted to Demo mode.
2. Select the firmware in the Update tab and press the flash button (you should see Recovery mode label immediately).
3. Connect the battery to your model (with USB interface connected). Then you should see a new flashing progress.
Spirit System developer
Top
Rcpassa
Posts: 55
Joined: Thu 15. Oct 2015 1:41:38

If it doesn't, what should I do?
Top
Rcpassa
Posts: 55
Joined: Thu 15. Oct 2015 1:41:38

It does not blink...what do I do??? This is getting frustrating.
Top
ZeXx86
Site Admin
Posts: 12832
Joined: Mon 29. Apr 2013 16:06:44
Contact:
Contact ZeXx86

It is not a problem. I will send you the guide in the private message.
Spirit System developer
Top
Rcpassa
Posts: 55
Joined: Thu 15. Oct 2015 1:41:38

Did you send it?
Top
ZeXx86
Site Admin
Posts: 12832
Joined: Mon 29. Apr 2013 16:06:44
Contact:
Contact ZeXx86

Yes.
Spirit System developer
Top
Rcpassa
Posts: 55
Joined: Thu 15. Oct 2015 1:41:38

Pls check your pm...
Top
Rcpassa
Posts: 55
Joined: Thu 15. Oct 2015 1:41:38

How long should the recovery take?
Top
Rcpassa
Posts: 55
Joined: Thu 15. Oct 2015 1:41:38

Once the unit is plugged in?
Top
Post Reply

Return to “Support”