Hello,
I just setup my TT E700 with the new 2.0.0 on a spirit pro.
Got all ok except swash should go down in positive collective.
I could solve this by reversing de collective channel in the transmitter but rescue collective is still in wrong ditection.
Is there a way to tell the fw that swash is reversed ?
Swash wrong direction on E700
You should not change collective in TX. As I guess Diagnostics is now wrong.
You should reverse Servos Ch1, 2 and 3 in Spirit following the Wizzard steps, till pitch is correct.
Than things should all work.
Or you might run in the issue like trailing blades.
http://www.spirit-system.com/phpBB3/vie ... 651#p13651
You should reverse Servos Ch1, 2 and 3 in Spirit following the Wizzard steps, till pitch is correct.
Than things should all work.
Or you might run in the issue like trailing blades.
http://www.spirit-system.com/phpBB3/vie ... 651#p13651
Last edited by Adrian on Fri 26. Feb 2016 20:03:04, edited 1 time in total.
Oxy4max SpiritPro + HW // SOXOS 550, SpiritPro, HW120A V4, 920KV // SOXOS 600, SpiritPro, HW160A, Pyro650 // SOXOS Strike7, SpiritPro, HW160A, Pyro750 // Skywing Spirit Aero // FrSky Horus X10S + Taranis X7 /
Well I tried that but in this case, directions are reversed.
Just looking in other posts it seems thisis the same issue as for Coco66 with his 450X
http://spirit-system.com/phpBB3/viewtopic.php?t=1203
Just looking in other posts it seems thisis the same issue as for Coco66 with his 450X
http://spirit-system.com/phpBB3/viewtopic.php?t=1203
Got the same in mind.....
Oxy4max SpiritPro + HW // SOXOS 550, SpiritPro, HW120A V4, 920KV // SOXOS 600, SpiritPro, HW160A, Pyro650 // SOXOS Strike7, SpiritPro, HW160A, Pyro750 // Skywing Spirit Aero // FrSky Horus X10S + Taranis X7 /
I think Tomáš will contact you since he can send you a firmware which is specific for trailing edge control.
They are currently implementing a specific setting in the official firmware/software, but meanwhile I got the "unofficial" one and it works perfectly (flown it already).
They are currently implementing a specific setting in the official firmware/software, but meanwhile I got the "unofficial" one and it works perfectly (flown it already).
Oxy 2 ♦ X-Vert ♦ Warp 360 ♦ Blade 450X ♦ Blade 450X Nightflyer ♦ Goblin 500 (RIP) ♦ 2 X mCPX v2 ♦ night fly mQX ♦ LadyMQX ♦ nano QX ♦ nano QX FPV ♦ Inductrix ♦ DX8 G1
I didn't receive any update but I could fly just like that : reversing the pitch channel and switching from rescue to stabilisation.
The E700 maiden went very well.
Just one thing : in fast circles in good wind the pitch was a bit too sensitive. The heli was going up and down without real will to do that on the sticks. But this is my first 700 probably nothing important.
The E700 maiden went very well.
Just one thing : in fast circles in good wind the pitch was a bit too sensitive. The heli was going up and down without real will to do that on the sticks. But this is my first 700 probably nothing important.
I have not received any message from you yet. But I will send you a link for the firmware.I highly not recommend to reverse pitch. It must be configured properly else other functions will not work.
Spirit System developer
