No pitch; and wrong direction of FBL in case of move

In case you do not know something or you are not sure, here is the right place for your question.
Post Reply
scvflyer
Posts: 98
Joined: Wed 22. Jul 2015 16:02:51

Hi serviceteam,
setting my spirit system (standard) after update - setting channels seams to be fine. Pitch movement is shown at general channel setting as well. But if i try to use pitch under normal circumstances - it doesn't work.
Second - setting direction of each channel has be done and works properly but - if Helicopter will be moved to one site (aileron) Spirit systems moves to same direction - but has to move against this direction
Any idea?
thanks in advance and br
siggi
Adrian
Posts: 204
Joined: Thu 08. Oct 2015 14:43:12
Location: Switzerland

Direction: This can have different reasons, usual if followed installation wizard, this should work.
Causes, Spirit pointing to wrong flight direction or servo plugged in on wrong ports in Spirit.
Oxy4max SpiritPro + HW // SOXOS 550, SpiritPro, HW120A V4, 920KV // SOXOS 600, SpiritPro, HW160A, Pyro650 // SOXOS Strike7, SpiritPro, HW160A, Pyro750 // Skywing Spirit Aero // FrSky Horus X10S + Taranis X7 /
scvflyer
Posts: 98
Joined: Wed 22. Jul 2015 16:02:51

Hi Adrian,
I fixed one issue - dircection of contra movement while moving heli has been fixed - I set reverse movement in spirit and normal at TX.
last issue - no pitch movement. Pitch traveling is shown at diagnostic tabs from spirit - therfor signal must be known at spirit

Aileron, elevator, rudder, rescue mode works fine.

Thanks supporting me br siggi
jgiannakas
Posts: 183
Joined: Sat 02. Jan 2016 12:17:50

If you're not getting any pitch (collective) you have rescue enabled & active.
scvflyer
Posts: 98
Joined: Wed 22. Jul 2015 16:02:51

Hi jgiannakas,
you are right - I have a mixer at TX and this doesn't work properly (after updating TX Software).
thanks and br
Siggi
Post Reply