[SOLVED] Taildragger inialazation

In case you do not know something or you are not sure, here is the right place for your question.
Post Reply
RidgeMan
Posts: 31
Joined: Fri 26. May 2017 0:58:57
Location: St.Louis, Missouri USA

I noticed the note:
Warning: If using these modes, be sure your model is initialized on a flat surface, not tilted to any side. Do not tilt the model for more than 5 seconds after initialization. It can be initialized in normal or inverted position.

Does this mean that you would have to hold the tail on a taildragger level during power up? Or just keep the wings level?
Last edited by RidgeMan on Sat 10. Jun 2017 16:30:07, edited 2 times in total.
Top
ZeXx86
Site Admin
Posts: 12750
Joined: Mon 29. Apr 2013 16:06:44
Contact:
Contact ZeXx86

Such angle as are present in taildragger models is not a problem, but bigger could be.
So just initialize the model in normal position and fly.
Spirit System developer
Top
Post Reply

Return to “Aero - Support”