[SOLVED] Hobbywing 130 V4 and Telem UNI cable with DS16?

[Franky13]

Hello!

I have a few problems with the Telem UNI with the Hobbywing 130 controller.

As far as described I have everything connected correctly. In the DS16 I have the ads; Temp, Cap, RPM, Volt, Current, Vips, but they are all zero? Only temp is at 25.5 degrees.
Software is up to date!

What can I do?

Greeting Frank

[ZeXx86]

Hello Frank.

Please check firmware in the ESC. Older version does not support the telemetry.
You can also verify if you are using the primary satellite port.

[Franky13]

Hello Tomas!

Because of a shorter cable laying in the TDF, I used the Secondary Port.
I have now connected the primary port.
Now I have all the ads in the DS16 !!!

Thank you!

[ZeXx86]

Great! It must be always at primary port.