Hobbywing SCM connection ?

[Dawiev]

Hi,

HW released the module (SCM) to correct the telemetry for their OPTO modules. I'm using a 200A ESC.

With Spirit, the connection only takes the signal pin from the RPM port.

What is the correct way to connect this new module please ?

[ZeXx86]

Hi,

the R with Signal out will be connected by a single wire with the PIT pin or by a servo cable with middle pin removed (very important).

The telemetry (P) port (Signal out side) will be connected by the Telem UNI cable.

[Dawiev]

Thanks! !