Spirit Geo-Link Connection

[Jeeprogue]

I have a Spirit Pro and i am currently using an AR4649T with a Satellite and the Uni-Cable for HobbyWing Telemetry. My Geo-link arrives tomorrow and in the manual it specifies that the Geo-Link uses the Secondary Satellite port on the Spirit Pro, the Uni Cable for HobbyWing Telemetry uses the Primary Satellite Port. Is it possible to use a Y harness on one of the 2 satellite ports to and use the Telemetry, Geo-Link, and Satellite RX, or will i have to remove either the Satellite or Telemetry?

[rediary]

+1

Also very interested in how this will work!

[LogoX2]

Use a Spektrum V2 adapter to plug the Sat into the Rud port.
You can use a Y cable to apply power to the 4649T or power it
using the Aux 2 port.

[Jeeprogue]

i was scrolling through some of the other posts here, i came across this thread http://spirit-system.com/phpBB3/viewtop ... =20&t=2677 discussing setup using a Satellite RX and the Geo-Link on the regular Spirit, ZeXx86 specifies that on the regular spirit with only 1 port, a Y-harness can be used for the Geo-Link and Satellite RX. one would assume this means the same would work with the Spirit Pro?

[rediary]

Would something like this work providing power to two accessories from a single sat port?

https://www.amainhobbies.com/spektrum-r ... 1QQAvD_BwE

[LogoX2]

No you can NOT use a Y cable on the Geo Link.
It must be used by itself on the Sat port.

[ZeXx86]

Here is how you can connect 3x Spektrum satellites and 1x SPM4649T together with Spirit Pro.
You can also connect 4th Spektrum satellite instead of SPM4649T - it is only necessary to modify Spektrum adapter so that signal wire is separately connected at the AIL pin.