Cyclic Servos are shaking

[commonrailer]

Hi,

I am setting up my new spirit pro. All components like servos, RX, FBL are placed on the desk. After initialization, the servos starts to move with strong shakings when I change the FBL unit orientation by hand. Is this a normal behaviour or should there a smooth movement of the servos?

Best regards
Walter

[ZeXx86]

The unit should respond to the movements. Once unit will be mounted at the model it will look very differently, because hands can't make smooth movements with a small things. So I am convinced it is normal.

[commonrailer]

Ok. Thanks for quick reply. If I notice further servo shaking on mounted system I will contact you.