Hello serviceteam,
after a crash - I rebuild the system and did an software update for SpiritPro to 2.6.1.
But no channel signal from TX/RX recognized at SpiritPro - no physical reaction nor at diagnose screens at spirit software.
Current status:
* TX and Receiver has been changed to be sure that this part is fine - SUMD (test with Graupner) and SBUS (test with FrSky)
* Init phase seems to be okay - TS and Servos will be centered properly - but red light flashs
* BEC Test works well
* Adjusting Servo to get TS zero position - works well
* Reset to factory setting has no effect
Any idea
thanks and br siggi
[SOLVED] SpiritPro doesn't react on RX signals
Hello,
please make sure that the correct Receiver type is configured in the Spirit Settings and that it will persist after re-power.
I guess that the problem is just there.
please make sure that the correct Receiver type is configured in the Spirit Settings and that it will persist after re-power.
I guess that the problem is just there.
Spirit System developer