Spm6210t & ix12 and spirit 2

[Neilsteers]

Looking for help, have the 6210t connected to the spirit by JETI cable red and brown rudder and orange to pit, esc to aux1 , if I connect servos to rx they respond but connected to the spirit 2 they don’t and in both scenarios the bars do no move in the channel screen in the spirit wizard, what am I doing wrong ?

[10x]

I assume you mean the 6610t?. Have you set receiver type to SRXL2 in the Spirit in the general tab, then in rx....

[Neilsteers]

Hi
Yes the 6610t, and yes set to srxl2

[HeliMLM]

.....and orange to pit...?

if you have really connected to PIT (middle pin) this is the problem... check wiring with Spirit manual: should be the topmost pin iirc.

[Neilsteers]

Hi Michael no the orange wire is in the top pin

[HeliMLM]

Ok... would have been an easy one

and the firmware on 6610T is updated and Spirit is using actual firmware?

[latjo-k]

HI follow this thread.
http://spirit-system.com/phpBB3/viewtop ... =20&t=3791

[Neilsteers]

I have updated the rx but not the spirit software, software on wizard is showing latest release 2.8