Kontronik TelMe settings in ESC

In case you do not know something or you are not sure, here is the right place for your question.
Post Reply
buttles
Posts: 156
Joined: Tue 16. Jun 2015 14:37:10

I have searched, promise! Just need to confirm the progunit settings in the Kosmik and Jive Pro.... Is it Motor Poles 2 and ratio of 1.0:1?
I know the Spirit needs the correct details entered. Thanks
Top
ZeXx86
Site Admin
Posts: 12836
Joined: Mon 29. Apr 2013 16:06:44
Contact:
Contact ZeXx86

Hello,

yes. This is default settings and should work well.
Spirit System developer
Top
buttles
Posts: 156
Joined: Tue 16. Jun 2015 14:37:10

Thanks Tomas, thought so!!
Top
azaz44
Posts: 288
Joined: Thu 12. Jul 2018 17:51:47

Just wondering, why not set it properly? In Kosmik you will then get the right RPM in the log files.
Top
buttles
Posts: 156
Joined: Tue 16. Jun 2015 14:37:10

'Cos in Jeti Data Analyser you get the same
Telemetry will work properly as well
Top
buttles
Posts: 156
Joined: Tue 16. Jun 2015 14:37:10

Is there a reason the Spirit Telme to Jeti doesn't include BEC voltage from Kontronik ESCs? It's rather an important bit?!! Back to jLog otherwise...
Top
buttles
Posts: 156
Joined: Tue 16. Jun 2015 14:37:10

azaz44 wrote:Just wondering, why not set it properly? In Kosmik you will then get the right RPM in the log files.
Kontronik Device Explorer has entries for divider and pole count so basic info into it can be shown correctly
Top
azaz44
Posts: 288
Joined: Thu 12. Jul 2018 17:51:47

buttles wrote:
azaz44 wrote:Just wondering, why not set it properly? In Kosmik you will then get the right RPM in the log files.
Kontronik Device Explorer has entries for divider and pole count so basic info into it can be shown correctly
Ok, that makes sense. This removes the need to reconfigure the Kontronik when you change gearing.
I didn't notice that in Kontronik data explorer, but will check next time I use it.
Top
Post Reply

Return to “Support”