Rudder ESC - range (tunning)

[daniel_i]

Hi,

I fail to understand how this tab should be setup Rudder ESC - range (tunning)

What I do:
1. Existing values from the manual

1.png (3.21 KiB) Viewed 353 times

1. I tick the checkbox
2. motor starts idle at low speed
3. once I click any slider motor starts spinning at full speed.
4. at this point already have less than 5 seconds to act since this can burn the motor/esc
5. I quickly move the left side slider to get any feedback from the motor
6. from multiple tries I figured out that motor stops at ~200 value.
7. any other value does no change - motor spins at full speed

Can I get some hints if this works correctly or do I miss some steps?

[ZeXx86]

Hello,

the process seems to be good.
At step 7. you should start from the lowest value. If it will still spin up quickly, then please set the lowest value.