[SOLVED] Spirit 2 and Jeti DS16

[nzlsubzero]

Hi

I am trying to get AUX1 working for the throttle. I have assigned the 'Throttle' in the setup to Channel 1. This should have the throttle output now on AUX1 output from the unit. The ESC however will not initialise. If i however use an RX output to the ESC, I can get the ESC to work. I would prefer to use AUX1.

Any suggestions will be very helpful.

Thanks

[ZeXx86]

Hi,

it is enough to recalibrate the ESC, because it has throttle range from the receiver.
Or you can change settings in the Spirit unit in the General - Throttle - Throttle Range so it will match the old range from receiver.

Range from receiver is 1000 - 2000us. So after changing everything should work.

[nzlsubzero]

Hi ZeXx86



That worked. Excellent.

Thanks for the prompt response. Much appreciated.

Cheers