Update 3.2.2

[Manfred]

Hi,

sure, same radio without changing anything, but other Spirit RS unit.
Updated the RS unit to 3.2.2 and it`s fine.

Checked it more than one time, it is still working.

Best
Manfred

Updated my 3rd RS unit, still working fine also

[Manfred]

Wait please.

Replaced the RS unit by another one on the Helicopter.
Did the Setup......(new programming)

Same problem at hand again.

So, now 2 units are effected,...... it`s not a Hardware mailfunction.

Best
Manfred

[Manfred]

So,
worst case now.

All my Spirit RS units have now this picture of failure.

I flashed back to 3.2.1 and 3.2.0 but it seems that my bin files are the wrong ones.

Can you please send me this file, that a can bring my systems back to the pre-version, please

#
Thats really frustrating

Best
Manfred

[Habásek]

Hello, please send a photo of the helicopter as you try on the table.
Don't you have too close to the radio? ... at least 50cm from the receiver antenna.

[Manfred]

It's unclear why you asking for, however.
Attached all 3 units, before update all
3 units works fine, same distance....

I'm really not a newbie.

2 units on 2 different Helicopter
1 unit dismantled of the 3rd Helicopter.
All 3 units seeable on the picture.

Distance around 1 meter to radio.

Manfred

[buttles]

Have you tried powering up the Spirits with a battery on their own? Maybe do a fresh install on one? Odd one indeed.....

[Manfred]

I already did that.
The dismantled one with a 6 V external Battery, without any other cables.
A completely new fresh installing on the Goblin 380

Gents:
Please check your update.
I can not provide further investigations.
A movie, plenty of firmwareupdates....., it is not a hardware failure.

With updating on 3.2.2 the never ending story has started.

Manfred

[Habásek]

Manfred,
I have 4 heli. I have an RS unit on two heli (fw 3.2.2).
Radio DS12 (fw 5.05). I'm trying to duplicate your problem but I can't.
I will also try the DS16 radio in your configuration tomorrow.

link for last Jeti integration : https://spirit-system.com/dl/jeti/SPIRIT-3-2-2.zip
link for manual Jeti integration : http://manual.spirit-system.com/index.p ... ntegration

Habasek

[Manfred]

RS Unit on Goblin 380

Flashed it back to 3.2.0

Copied (from my HD) old backup (don`t know the release) to the device folder of Jeti Ds-16

Everything is working fine on any distances (radio to unit)

I can go through all screens.

For your information.

i`ll end the investigation / trials now.

Manfred

[Klaus]

I also have some troubles with the Jeti integration in 3.2.2.
When I enter the Device Manager in my DS12 (FW5.03) first all menues are visible, but when I enter for e.g. the Common menue and then go back to the main page the servo menu is not more present. Also when I enter the common menue again parts of this menue are missing.
After restarting the Spirit RS-unit all menues are visible again, and so on.
The unit is still working properly, but the Jeti integration is faulty and the blue LED on the unit is blinking also after exiting the device manager.

Best regards
Klaus