GT initializing

[heri]

As I told you, I have the same problem. I use a buffer capacitor to buffer the sevo peaks. I disconnected these buffer, and the problem was gone.Just to think about it.

BR

Heri

[10x]

I am not using a buffer cap but i am using a Optipower ultra guard....Be interesting to know if HeliMLM is using any thing like this....

[HeliMLM]

Hi,

buffer cap (16V 4700uF) is always connected on all of mine, just tried with R2 buffer (smaller one) instead and in both cases no problem with initialisation... but only w/ YGE bec, i cannot easily repeat the test w/ a lipo.

[10x]

Hi,

buffer cap (16V 4700uF) is always connected on all of mine, just tried with R2 buffer (smaller one) instead and in both cases no problem with initialisation... but only w/ YGE bec, i cannot easily repeat the test w/ a lipo.

Thanks for that Michael...Just disconnected the Ultra guard to see but no difference, still needs the double connection....

[10x]

Hello Tomas
Still getting this fault, here is a log taken today after problem...
Picture attached....Hope this will help...
Regards Adrian

[Dr.Fleming]

As I told you, I have the same problem. I use a buffer capacitor to buffer the sevo peaks. I disconnected these buffer, and the problem was gone.Just to think about it.

BR

Heri

I use 1ST Buffer connected to the "GT" AUX 2 on all my Heli's, no problems.

[heri]

Hello, the problem reappeared. So it looks like the buffer was not the problem. But, when I look at the picture of the log, maybe it is a problem with the voltage. At the second try, the unit is preloaded and voila it starts. It is just a guess of me.

Heri

[10x]

I have been trying different things but still does it...

[ZeXx86]

Can you try to turn off RealTime logging only for verification if it makes some difference please?

[10x]

Hello Tomas
Should the real time logging menu be in the jeti intergration under diagnostics? as i can not find it on the jeti but it is there on the pc setup...