[SOLVED] Spirit2 - fport - No telemetry

[jjuk]

I have set up a Spirit 2 (v3.5.0) with a r-xsr f.port receiver running ACCST v1.

The spirit 2 is receiving channel information correctly. It's fully operational.

The spirit 2 doesn't seem to be sending any telemetry information back to the radio, also the OpenTx scripts are not loading (because the spirit 2 isn't sending telem back to the radio).

[ZeXx86]

Hello,

we have exactly this receiver and it works with F.Port well, including telemetry and integration.
Do you have something else connected to F.Port bus?
Is F.Port receiver type configured in the Spirit unit?

[MegaHz]

Make sure you have the connector plugged in the right way. The exact situation happened to me. in ACCST you should be on S.PORT technically

[jjuk]

My r-xsr is connected as follows:

https://oscarliang.com/wp-content/uploa ... 24x591.jpg

Code: Select all

Un-inverted smart port -> Spirit 2 ELE/PIT/AIL top pin
RX Power               -> Spirit 2 RUD top pin
RX Gnd                 -> Spirit 2 RUD bottom pin

Receiver is set to "FrSky F.Port"

I have full control, but no telem.

[ZeXx86]

Maybe problem is here:
RX Power -> Spirit 2 RUD middle pin

[jjuk]

Sorry that was a typo. The power is connected to the centre pin.

[Vector]

Did you updated r-xsr with last FW ? And did you put rx in f.port mode?

[jjuk]

Here are all the software versions that I'm using:

Spirit 2 v3.5.0, 4ds file attached.

500x fport with stab.4ds

(255 Bytes) Downloaded 97 times

R-XSR:
I'm running RXSR-FPORT_LBT_ACCST_191128.frk from here:
https://www.frsky-rc.com/wp-content/upl ... 191128.zip
The receiver is showing a green and a blue LED, which I believe means green=bound, blue=fport.

Transmitter:
Running OpenTx 2.3.14, and Spirit integration https://www.spirit-system.com/dl/opentx ... 4.3-en.zip

I have full channel control of the Spirit 2, all channels are working, so the receiver must be outputting f.port to the spirit, but the spirit isn't sending telem to the receiver.

[Vector]

Try this ACCST D16 v2.1.0, ACCST D16 v2.1.1(F.Port firmware update only )
GT 3.5 + R-Xsr 2.1.1 LBT and EdgeTX 2.8 integration 3.4.3 everything works great.

[jjuk]

Just flashed the transmitter to ACCST v2.1.0, and the r-xsr receiver to "RXSR_ACCST_2.1.1_Fport_LBT.frk."
https://www.frsky-rc.com/wp-content/upl ... v2.1.1.zip

I have full control of the model, but no telem is being sent back to the radio.