Mixing elevator to flaps in normal mode

In case you do not know something or you are not sure, here is the right place for your question.
Post Reply
Yogi43
Posts: 86
Joined: Sun 28. Dec 2014 22:39:47

Hi,
actually I'm setting up the Spirit Aero in a Freewing Avanti v2. When setting the flaps it is required to give 3mm elevator down. Is this also possible in normal mode? I assume in heading-lock mode it is not required. But how does the Spirit behave in normal mode?

The separate flaps are controlled by the receiver directly-
Top
Yogi43
Posts: 86
Joined: Sun 28. Dec 2014 22:39:47

No idea? The next day with good weather conditions I just will try it out. I have defined a trim switch so that I can set the mixing on elevator to zero in case of any problems.
Top
ZeXx86
Site Admin
Posts: 12749
Joined: Mon 29. Apr 2013 16:06:44
Contact:
Contact ZeXx86

Hi,

it should work well if the Flaps are controlled from the Receiver directly. Will work with HL or Normal mode.
Spirit System developer
Top
Yogi43
Posts: 86
Joined: Sun 28. Dec 2014 22:39:47

Hi, thanks

should work means that no elevator mixing is required in HL? What about the mixing in Normal mode?
Top
Yogi43
Posts: 86
Joined: Sun 28. Dec 2014 22:39:47

Are there any updates on that point?
Top
Post Reply

Return to “Aero - Support”