Spirit GT with Fly Sky FS-iA10B extra channels?

[helicopterjeff]

I finally have my GT setup and working well. I paired it with a Fly Sky FS-iA10B 10 channel RX and a RadioMaster TX16S

The TX is setup for FlSky2A mode and PPM,SBUS protocol.

I need access to the upper 3 channels- 8, 9, 10

How do I do this?

All the channels on the RX are dead. The only port used is the bus channel.

Are these channels (not used as far as I know by the GT) usable in this config? If not, how would I accomplish this?

Thanks!

[ShapeShifter]

I have the exact same setup and have the same question.

[ShapeShifter]

I finally have my GT setup and working well. I paired it with a Fly Sky FS-iA10B 10 channel RX and a RadioMaster TX16S

The TX is setup for FlSky2A mode and PPM,SBUS protocol.

I need access to the upper 3 channels- 8, 9, 10

How do I do this?

All the channels on the RX are dead. The only port used is the bus channel.

Are these channels (not used as far as I know by the GT) usable in this config? If not, how would I accomplish this?

Thanks!

Look at page 33, sect 9.2 in this doc: https://www.horizonhobby.com/on/demandw ... aign=41227

It talks about how to configure the FS-iA10B Rx for PPM through menus on the Flysky transmitter, however, it implies that when PPM output signal is active, all other channel outputs are disabled. This my be our answer (unfortunately). Spirit support team may have more info, but the FS-iA10B may not be the way to go if more channels are needed.