Tx16s zeroed but showing -5 pitch in servo page.

In case you do not know something or you are not sure, here is the right place for your question.
Post Reply
Mistralis
Posts: 1
Joined: Mon 23. Aug 2021 15:48:55

Hi when I come to set up the servos in Spirit software I get - 5 on the pitch indicator with the tx showing 0 output and -10 at bottom stick with with the tx showing -100. Is it the tx or what?
Top
Mattes61
Posts: 637
Joined: Wed 21. Dec 2016 15:13:38
Location: Germany

Hello,
show an screenshot at spirit settings...
At first you have to set your servos individually at the middle impuse 1500/1520 then put the servohorns on that it is perpendicular to the servo case - that you should do on all sevos at first. Then mount these servos in the helicopter -after that you have to take a swash leveler (for swashplate) and adjust that the swashplate is leveled out. At this position the pitch must be adjusted to 0° - this is your Initial setup for the rest of the settings in the Spirit Settings Software -

Best regards
Top
Post Reply

Return to “Support”