Setting Flight Modes / Tuning

In case you do not know something or you are not sure, here is the right place for your question.
Post Reply
bovi7
Posts: 8
Joined: Wed 04. Feb 2026 8:39:56

I prefer Flight Modes over Banks. I have 5 Flight Modes (Idle-Up 1-3, Off and Hold) with different throttle and gain settings. Now I would like to assign additional Parameters to the Flight Modes, for instance Swashplate Stop Smoothing.
To set a Parameter, I go to the respective Flight Mode and adjust the Parameter.
However, when I switch to Flight Modes Idle-Up 1 to 3, the throttle is activated and the motor starts to spool up. How can I temporarily disable the motor while setting/changing these additional parameters?
I could disconnect the motor, but that is not very practical when I’m out in the field. Another method might be to set Throttle Out to 0, but this is not practical either.
Top
Post Reply

Return to “Support”