3d Master Mode issue

In case you do not know something or you are not sure, here is the right place for your question.
Post Reply
IFHELI
Posts: 26
Joined: Sun 21. Sep 2014 22:23:28

I have two Spirit GT and two Spirit II. The 3D master mode will only stay checked on one Spirit GT in all three banks. On the other three units it will only stay check in Bank 0. What am I missing here?
Top
ZeXx86
Site Admin
Posts: 12920
Joined: Mon 29. Apr 2013 16:06:44
Contact:
Contact ZeXx86

Please try to redownload the PC software. It should be available only in Bank 0 and will affect all. If it is enabled, it will be enabled for all Banks.
Spirit System developer
Top
IFHELI
Posts: 26
Joined: Sun 21. Sep 2014 22:23:28

The redownload of the PC software worked on the Spirit GT. It not work for the two Spirit II.
Top
ZeXx86
Site Admin
Posts: 12920
Joined: Mon 29. Apr 2013 16:06:44
Contact:
Contact ZeXx86

Hello,

the problem could be that in your Bank 1 and 2 there is way too old settings saved that is not compatible with the latest one. For example from version 4.0.1. Since then there was no change in these banks and this will block new 3DMaster mode.

It is enough to save the settings in Bank 1 and Bank 2 and all should be OK.
Spirit System developer
Top
Post Reply

Return to “Support”