Note:- I'm using the Wifi link 4.0.3
Realizing part of problem is setting up the Spektrum Transmitter. So I asked on a Spektrum forum how to make the same switch as the Bank switch change the Gyro channel 5 in my transmitter.
I got Gyro channel to change values from 70,60 and 50 to match each change of bank 0, 1 and 2
Bank 0 Gyro 70
Bank 1 Gyro 60
Bank 2 Gyro 50
But the value of Gyro Rudder Gain still does not change
End Of UPDATE.
Specifies Gyro Gain Rudder Gain :- is Grayed out - Inactive if Gyro Gain is configured in the transmitter
I'm using Banks 1,2 and 3 I would like Rudder Gain to be in the Banks so it can be head speed specific; if that makes sense?
How do I remove the configured Gyro Gain in the transmitter that is currently on a three position switch (not my Bank switch)?
I did it that way because I wanted a rate mode to check if tail was set correctly.
Is the correct way to go to the channels menu and set Channel 5 that currently controls Gyro gain to Unassigned?
Spektrum transmitter.
Helicopter is a standard build OMP M4 Max.