Hallo,
today I try to adjust my sprit. The tail servo (rudder) is on CH4. The diagnotic shows me +-118% but if I move the stick the servo makes only 4mm way.
I tested a other channal an the servo makes the hole way. Its a BLS954. Frequenz is 1520 and 333.
Does anyone have an idea?
Regards Jens
Tail Servo doesn´t work corrrect
Try to set Head Lock mode, your gyro is most probably in Normal/Rate mode.
You can just set Gyro gain so the diagnostics will show HL instead of N.
You can just set Gyro gain so the diagnostics will show HL instead of N.
Spirit System developer
Ok I raise the gain and the servo starts work correctly 
Now I have the problem that CH4 is not CH4 in my Radio control. I used a DS16 with Jeti Rsat.
The servo display show me the channels for example CH3 Pitch. If I change CH3 in the Spirit Sotware to Pitch it doesnt work.
Now I have the problem that CH4 is not CH4 in my Radio control. I used a DS16 with Jeti Rsat.
The servo display show me the channels for example CH3 Pitch. If I change CH3 in the Spirit Sotware to Pitch it doesnt work.
Great.
This is not a problem. Channel numbering is different between each transmitter/receiver.
It should work with defaults settings.
This is not a problem. Channel numbering is different between each transmitter/receiver.
It should work with defaults settings.
Spirit System developer