Hello,
when I use the rescue function (Acro) the tail gets an quick oscillation.
How can I change this? (Voodoo600 BLS251 Servo)
Regards Jens
Tail oscillation by using rescue funktion
-
linux-user
- Posts: 45
- Joined: Fri 19. Dec 2014 18:37:00
- Location: near Munich
What is your gyro-sense?Voodoo2 wrote: when I use the rescue function (Acro) the tail gets an quick oscillation.
Maybe gyro is set to high.
It also may help, if you post your settings here.
Hello,
you have to configure Gyro Gain to the same value as in your conventional flight. So if you are using +60% for normal flying, for the rescue you have to set -60%.
You can also decrease little bit for the rescue.
you have to configure Gyro Gain to the same value as in your conventional flight. So if you are using +60% for normal flying, for the rescue you have to set -60%.
You can also decrease little bit for the rescue.
Spirit System developer
