Page 2 of 2

Re: vibration level in flight [3.0.0 rescue problem]

Posted: Thu 16. Apr 2020 14:12:46
by HeliMLM
Hello Tomas,

the good news: heli still alive after ~15 rescues (normal) in one flight 8-). outside temp was ~20°C and very sunny, almost no wind. heli was cool from garage/underground (car showing 13°C). 3 minutes by car to the field - flying directly after arrival. so heli/unit was still warming up...

i gave it 30" after power up. the first 2 rescues (early in flight, <1 minute) have been a little bent to the right (15-20° - hard to say exactly as it was high to be secure) and all the rest was good... from all situations including inverted fff, inverted piros, inverted funnel... Spirit did what one could expect. *thumbs up*

same after landing - no problems / rescue fully level... and no log available when powered up next time at home :)

Re: vibration level in flight [3.0.0 rescue problem]

Posted: Sat 25. Apr 2020 10:06:46
by HeliMLM
... just been out @ ~10°C and rescue again is strongly bent to the right, a little back. so i would say you are right for sure, Tomas => temperature related problem. how to solve this now?

Re: vibration level in flight [3.0.0 rescue problem]

Posted: Tue 19. May 2020 12:47:25
by HeliMLM
ZeXx86 wrote:...then we know the problem is due to cold temperature and can be resolved very likely easily...
Hello Tomas,

problem still existing... again this morning. as you said "can be resolved likely easily": does this mean with the re-release of 3.x or what else is the solution?

thx
Michael

Re: vibration level in flight [3.0.0 rescue problem]

Posted: Tue 19. May 2020 12:51:26
by ZeXx86
Hello,

yes, problem will be resolved with upcoming firmware.

Re: vibration level in flight [3.0.0 rescue problem]

Posted: Tue 19. May 2020 14:19:02
by HeliMLM
thx a lot, Tomas! :)