Spirit System

Many thanks man!

Did I get you right?

correct, you do not need ground for tail signal on any of the available FBL systems (JST2 is sufficient to hold signal cable)

fassla wrote:I can see you have rudder frequency 50Hz, switch to 333Hz, and delay to 0.

Hi @fassla I didn’t get you with rudder frequency, where is this setup? You actually mean pirouette consistency?


Sent from my iPhone using Tapatalk

Huge thanks @fassla
Managed to get this thing in air. Btw are you in spirit team or ...?

https://youtu.be/04BevZAqBsE

Now of course tail does a bounce back and cyclic has a bit of shaking but I think this should be addressable through the parameters.


Sent from my iPhone using Tapatalk

happy to see you are up in the air

and, No I'm not in spirit team

fassla wrote:happy to see you are up in the air

and, No I'm not in spirit team

Thanks! tail and cyclic are fine.
I am now trying to figure out why I don`t get the current RPM value through that MTX pin.
I plugged that into P pin of P/E/A port of uSpirit and I get no output.
Also I counted 24 poles in the sunnysky motor => 12 value in sensing divider, right?

Hi,
did you plug into middle pin? i would say the manual could be misleading in that point...it says: „μSpirit - P pin - pin in the middle of P/E/A port“… but maybe i am wrong… do not know microSpirit.

I think Tomas needs to have a look on it. Neither P nor E on uSpirit is delivering a RPM value

fassla wrote:I think Tomas needs to have a look on it.

Okay, but is your setup reading the current RPM?


Sent from my iPhone using Tapatalk

for some reason I use the OMP ESC on a different FBL system....and there it is working as I showed to you