Re: Nitro gov does not hold RPM
Posted: Fri 03. Sep 2021 13:28:53
Ok, I think I understand better now, setup should be configured as follows:
1 magnet north, 1 magnet south, set sensor divider to 1 in software
or
both magnets (same polarity) facing up, set sensor divider to 2 in software.
I have to ask now, what do you recommend? will having 2 magnets facing up (sensor divider set to 2) have more resolution? hold RPM better?
Thanks
1 magnet north, 1 magnet south, set sensor divider to 1 in software
or
both magnets (same polarity) facing up, set sensor divider to 2 in software.
I have to ask now, what do you recommend? will having 2 magnets facing up (sensor divider set to 2) have more resolution? hold RPM better?
Thanks