Spirit System

Please check value in the Diagnostic tab that is going to the unit. What value it is when you enable rescue?

Hope these will help.

Functions:



Idle 1





Spirit Gyro Idle 1 Rescue Diag Value



Spirit Gyro Idle 1 Auto Rotation Diag Value



Idle 2






Spirit Gyro Idle 2 Rescue Diag Value



Spirit Gyro Idle 2 Auto Rotation Diag Value



Idle 3





Spirit Gyro Idle 3 Rescue Diag does not show rescue activating when in Idle 3.

Spirit Gyro Idle 3 Auto Rotation Diag Value

Thank you very much for the screenshots.
I believe that the problem could be in the first shot (Jeti menu), where you can see 50% in the gyro channel and assigned switch.
As you can see, assigned switch Sa is used as Trim and 50% as trim max value.
I recommend to unassign switch Sa and assign it in the column as in other channels. And also you can delete 50%.

Then I believe it will work correctly.

We are preparing Jeti configuration guide and profiles, so then it should be very easy to setup.

OK. I will try that and report back.

I used your screen shot from the first page as reference when setting the Gyro sens. Function.

Yes, there are more possibilities, but I think that this way will be better and will not cause any problems.