Hello, it should be at the P pin. With JST-Servo adapter it is middle pin, but without the adapter it is upper pin (pin where red wire is connected normally).
Manual was corrected.
Re: uSpirit severe tail wag - motorized tail
Posted: Sun 25. Oct 2020 14:00:23
by daniel_i
ZeXx86 wrote:Hello, it should be at the P pin. With JST-Servo adapter it is middle pin, but without the adapter it is upper pin (pin where red wire is connected normally).
Manual was corrected.
we will try the same with our M2. It is only very busy time so at the moment we dont know what to do sooner..
I will let you know.
Re: uSpirit severe tail wag - motorized tail
Posted: Wed 28. Oct 2020 17:44:34
by daniel_i
Hopefully you will deal with this issue soon because the unit looks promising.
I did some test flights and I can see some nice things with this unit.
Unfortunately without a governor, RPM drops too much.
I published a video to sum it up:
Re: uSpirit severe tail wag - motorized tail
Posted: Sat 31. Oct 2020 22:50:47
by daniel_i
ZeXx86 wrote:Hello,
we will try the same with our M2. It is only very busy time so at the moment we dont know what to do sooner..
I will let you know.
Hi, any update on this?
Can I help in any way? How can I make sure that I don`t have a faulty unit or there is no software problem in reading the RPM?