Spirit System

Tested following:
New firmware 3.2.2 and old bin file -> same problems.
Then I again installed new Jeti integration files -> same problems.

At last I assigned a bank switch in my Radio and everything in Jeti Integration works well now.
I think new firmware 3.2.2 needs to assign a bank switch, otherwise Jeti Integration works strange.

Regards, Klaus

We have tested with DS16 and latest firmware, Banks assigned and Banks unassigned.
Result is, it is working just perfectly in our case with all latest files.
Firmware 5.05 is working also well with DS12.

For this reason we would like to get your Spirit Settings file and we will load it to our units and retry.

We have tested also with Manfred's settings file and again, everything is OK.

Do you think it would be possible to disconnect everything from the unit, except BEC and retry?

I also tried to disconnect the telemetry sensor (Kontronik Kolibri) but that makes no difference.

Attached the old 4ds file.
In this setting also no channel is assigned for bank in the RS-unit.
Also I could not see the headline like Bank 0, Bank 1, Bank 2 in the Jeti Integration menue.

In my new configuration with assigned bank switch and bank channel mapping everything works perfect.
So no problem for me anymore.

Regards
Klaus

Could you please try to update to 3.2.2-r2 firmware version? It is available in the Spirit Settings from now.
I hope this can help you.

Tested the r2 version of Firmware.

Now it also works fine with no bank channel mapping in the Spirit-RS unit.

Thanks and best regards
Klaus

Oh, perfect. So now everything is resolved?

Yes, everything resolved now.
Thanks for your quick update.

Klaus

Hi everybody,
is it recommended to update from 3.2.2 to 3.2.2-r2 firmware version for everybody?
What are the improvements / changes?
Best regards
Werni