Spirit System

I just saw this in one of the older firmware updates where it says that throttle settings can be changed even with the gov disabled. Do I need to configure the throttle/gov settings tab even though im using the hw esc gov?

If your ESC is connected to the unit (nor a receiver), then it may be necessary to configure throttle range. But if it is working correctly now, there is nothing else you will need to configure in the unit.

To this end, I have a problem.

Kontronik (Jive Pro and Kosmik) should be taught with gas 0-100. This value is unfortunately too high for the Spirit. It maximized at 109% which about 83% are in the Jeti.
By Teach 0-100 has with the gas value (in the Jeti) also equal to the percentage of the maximum speed. One does not have this so test only

A change in the way the Governor-menu -50 - +150 unfortunately brings nothing.

Can that possibly be adapted?

I recommend to move in the opposite direction for Throttle Range - Min.
So for example your ESC could recognize throttle signal at around -115%

You can start the helicopter and slowly decrease the value until ESC will beep classic sequence.