Spirit System

Hello!
My Spirit software does not start anymore ...?
I can only open the demo mode.
The spirit works normally The software I have already installed!
My other Spirit FBL work!

Thanks!

Make sure the plug to the FBL is fully in... that's what happens when the PC Software does not "see" the unit...

Alternatively the USB interface was damaged, please check that the wires are good, especially on the PCB.
Some users are pulling it by cables, which is not making them happy
Or do you remember what was the last operation when it worked? Did you reconfigured something?

Tomas, you're right!
I have the cable re-soldered and the software works again perfectly!

Thanks!!!

Greeting Frank

Good job!
Thank you for the message.

Hi!
I do not know what's going on, now it is not again. Again goes only the demo mode ...?

Hi,

maybe the problem is again there.
From the photo I can see that there is some wire which is nearly touching other one.
Maybe it shorted there.

Sorry Tomas,
the second photo is after the new soldering.
No cables or contacts touch on the photo.
Another idea?

Are you sure that you have not enabled for example Kontronik telemetry? This would disable USB communication as described in the Telemetry window.

Tomas, this is another post...!?