Page 1 of 1
Help with Hobbywing SCM please ?
Posted: Thu 21. Jun 2018 3:31:17
by Dawiev
Hi, I need some help / guidance with the wiring to use the HW SCM module please.
I'm using a Spirit Pro, SPM4649T and a HW 200A ESC. Should I connect the throttle lead through the SCM ? Should I take the +, - from the Aux port on the ESC anywhere ?
Attached is the manual for the the SCM module.
Re: Help with Hobbywing SCM please ?
Posted: Sat 23. Jun 2018 1:40:45
by Dawiev
Bump. Help needed please !
Re: Help with Hobbywing SCM please ?
Posted: Sat 23. Jun 2018 16:22:20
by ZeXx86
Hello,
you do not need the SCM module.
But it could improve RPM or telemetry connection.
Unfortunately I can answer your question on monday. I hope it is OK.
Is there any problem you are having right now?
Re: Help with Hobbywing SCM please ?
Posted: Sat 23. Jun 2018 18:07:25
by Dawiev
Thanks for the reply.
I get all the telemetry values, except mah consumed.
Monday, no problem. Thanks in advance
Re: Help with Hobbywing SCM please ?
Posted: Mon 02. Jul 2018 3:47:57
by Dawiev
Maybe this Monday ?
Re: Help with Hobbywing SCM please ?
Posted: Mon 02. Jul 2018 7:44:14
by ZeXx86
I am very sorry for delayed reply.
You can connect it according the manual that you have attached.
Throttle signal can be connected directly to the AUX port of the unit while Telemetry data should be connected through this SCM module.
This module is designed mainly for RPM and Telemetry data ports of the ESC. But if you do not use RPM lead you do not have to connect it anywhere.