Page 1 of 1
Castle esc setting up
Posted: Mon 25. Jun 2018 21:52:13
by Martind
Hi everyone I’ve been having trouble trying to setup the end points on my ice 50a esc via the spirit. I can get it set on the rx (frsky xr4sb) on ch3 but as soon as it in the fbl unit it get no signal? The hw was fine.
Re: Castle esc setting up
Posted: Wed 27. Jun 2018 7:44:08
by ZeXx86
You only have to proceed according the manual.
Please see this page:
http://manual.spirit-system.com/index.p ... Castle_ESC
If it will not work, then please try to decrease Throttle Min. range down to 1040us.
This should help.